New Electop LED Strips for TV Backlight with Remote Control, USB Powered Light Strips Multi Colors LEDs Bias Lighting for TV PC Desktop

Feature

24-Key Remote Control: 16 buttons for Multi Colors, 4 buttons for Lighting Modes ( flash, strobe, fade and smooth ), 2 buttons for Brightness Adjustmen / Speed Adjustment, 2 buttons for ON/OFF Switch.
Perfect DIY Kit: 4 Pin on the strips can be pulled out. Just tear off the yellow non-stick tape from the back side of the led strips, then you can stick to different shapes at your will. 2 types of strong adhesives are used to fixed cables and control box, providing secure and strong installation without worrying about falling off.
Waterproof & Silicone Material: IP 65 Waterproof, available for both outdoor and indoor decorations even in rainy days. Silicone material, good light transmission, good toughness, you can make different shapes at will. Touch safe, it will not overheat after many hours using.
Relieve Eye Strain: led Bias lighting makes your home like theater, your display will be clearer. Bright and gentle backlight help to reduce eye strain while you enjoy the movie.
Application: Enhance your viewing pleasure with your lovely family with a dynamic and vibrant light. USB Powered, available everywhere when there is a USB Port, such as TV back, dining table, desktop back, dressing-table, etc.

Description

Package includes:
4 x 30 RGB LEDs Light Strip Male to Male 20.5 inches
2 x 4 Pin LED Connecting Cable Female to Female 20.25 inches
1 x USB-DC Power Cable 20.5 inches
1 x 24-key IR Remote Control ( Battery Included CR2032/CR2025 )
1 x RGB Control Box ( 2x1.31x0.81 inches, Input Voltage: DC 5V; Output Current: Max. 12A ) with IR Receiver
12 x Adhesive Cable Clips
1 x Double-sided Adhesive Square

Main Features:
Powered by USB.
Please peel off the adhesive tape before pasting to the surface.
DIY: Paste into Different Shapes According to Your Will.
DC port should be connected with the RGB Control Box.
Can be cut at the cutpoint into proper length.
Please pull out the transparent sheet when you use.
Make sure the remote control point to the receiver when you adjust different modes.

Installation Guide:
1.Clean the surface of the TV back with towel. Cut the adhesive tape from the end. Paste the LED strips on the TV back at your will.
2.Connect the DC port to the RGB control box, then choose an area near to the TV USB port to fix the control box with the double-sided adhesive square.
3.Connect the LED strips with the 4 pin cable and the control box. When you feel the 4 pin cables are too long, you can roll them up and use the adhesive clips to fix them on the TV back.