DEPO JDM Facelift Style Bi-Xenon D2S Projector Black Headlights Set Fit For 2003-2009 NISSAN 350Z Z33

Related posts

Feature

Brand NEW set (2 pieces, Left & Right) and Never been used, Unique JDM Facelift Style Black Housing with D2S Projector Lenses with Bi-Xenon Shutter built in, Amber LED side parking light -- Excellent for increased visibility and output!
x4 LED nodes for parking light, will remain AMBER LED - Just like factory! Parking Signal Light uses 3157 and T10 Size Bulbs (They are not included)
D2S Sized bulbs used for Low/High Beam (Bulbs and Ballasts are not included, please reuse existing setup) - For 2003-2005 years, please be sure to GROUND your ballast and re-wiring is needed. The original stock ballasts must be mounted securely and correctly to AVOID moisture from building up inside the lenses. Condensation usually occurs due to inaccurate installation, NOT because of the seal is broken.
Please note that you should get new seal gaskets (OEM Part # 26033M) to work with DEPO headlight as shown in the last photo. Your stock seal gaskets are probably worn out by now and no longer able to sufficiently prevent moisture/condensation. The OEM seal gasket is inexpensive, around $7, you will need two total (one for each side), is crucial to avoid water leak or condensation issues. Condensation is not covered under manufacturer warranty.
Water and Shock resistant, item is made by DEPO, SAE / DOT Approved. No Bulbs nor ballast is included, you can use your stock parts directly transfer to the new headlight to use. Although DIY is possible. PROFESSIONAL INSTALLATION is RECOMMENDED, NO instruction will be included except the manufacturer's original ones if there is any.

Description

This listing is for a BRAND NEW set (2 Pieces, Left & Right) of JDM Facelift Style Bi-Xenon D2S Projector Black LED Headlight assembly for 2003-2009 Nissan 350Z Z33 with Factory Xenon Model only. Made by DEPO, DOT/SAE approved. No Xenon bulb nor ballasts is included. Purchasing a set new of OEM ballast seal rubber ring (OEM Part #26033M) is required to avoid condensation after installation.